How to improve the working ability of sand making process?

In the actual production process of building sand, the production capacity of sand making machine will be affected by many factors. These factors can be roughly divided into five categories according to the experience of many users and the scientific analysis of the manufacturer. The corresponding solutions are put forward according to the results of these five aspects. The following is for your reference:

Material composition: the more fine powder in the material before sand making, the more influence sand making, because these fine powder is easy to adhere to affect transportation. Therefore, the material with high content of fine powder should be screened one time in advance. Fine powder will be screened out from the material as far as possible, so as not to affect the normal operation of sand making equipment.

Hardness of material. The harder the material, the more difficult it is to break up, and the worse the wear on the equipment. Sand-making speed is slow, of course, sand-making capacity is small. This requires us to choose the right material.

The fineness of material after sand making is required to be high, that is, the finer the material produced, the smaller the sand making ability. In this respect, it depends on the specific requirements of the concentrator. If there are no special requirements, the fineness of the material can be set to medium.

Material humidity, that is, when the moisture content in the material is large, the material is easy to adhere to the content of the sand making machine, and easy to clog in the process of conveying the material, resulting in the reduction of sand making capacity.

To solve this problem, first of all, the temperature of the material should be strictly controlled when selecting the material. If the temperature of the selected material is too high, sunshine or air drying can be used to reduce the percentage of moisture in the material.